


How to Scale Up
Calculating the Scale Up ParametersScaling up with radial flow columns is a simple matter, whether you are scaling up from a smaller radial flow column or from a conventional column. Radial flow columns are recommended for ion exchange, affinity, hydrophobic, reverse phase and other types of adsorptiondesorption separations.* The sample is bound to the column with one buffer and eluted under different buffer conditions. With this type of separation, the most critical parameter is residence time, or the time in which the sample is in contact with the packing material. This can also be thought of in terms of column volumes of flow per unit time.** Scaling up, from a small radial flow column to a larger one is linear. For example suppose you are currently running 3.5 mL sample on a 50 mL column at 5 mL/min. To scale up 400 X, simply multiply the column volume, sample size, and flow rate by 400. Therefore, a 1.4 L sample run on a 20 L column at 2 L/min will give the same separation. To scale up from a conventional column to a radial flow column, first calculate the flow rate in terms of column volumes per minute. For example, a flow rate of 25 mL/min through a 100 mL column is equal to 0.25 column volumes per minute. To scale up from 1 L column, the appropriate flow rate would remain a 0.25 column volumes per minute, or 250 mL per minute. Similarly, sample size should be thought of in terms of percentage of column volume. Since the bed depth of radial flow columns increases from 3.5 cm on the small columns to 10 cm on the large columns, a 3fold pressure increase can result. Process development on the small columns should be done at pressures under 8 psi. This will result in operating pressures below 25 psi on a large scale. *Isocratic separations that are dependent upon the length of column, such as size exclusion chromatography, are not recommended with radial flow columns.
**Because the design of radial flow columns is significantly different from conventional columns, the use of "linear velocity" (cm/hr) is not appropriate for calculating scale up parameters from Superflo® Columns.


